Wisdom light remote control lamp elevator chandelier mining lamp elevator
Rated power supply voltage: |
220V |
Power: |
25W |
Lifting device load weight: |
10KG |
Rated frequency: |
50HZ |
Weight: |
8KG |
Average rate of fluctuation: |
≥ 2.0m /min |
Anti-shock protection grade: |
class I |
Protection grade: |
IP65 |
Fire rating: |
F |
Remote control distance: |
<=30M |
Wire rope diameter: |
1.6mm (aviation class) |
|
|
I. product summary:
According to gb7000.1-2002 lamp safety requirements and experimental GB/ t15497-1995 enterprise standard system technical standards system composition and requirements and gb15092.1-2000 appliance switch part I: general requirements, developed and produced a new generation of electrical and mechanical integrated lamp lifting device for lamp replacement light source, maintenance of electrical appliances.
1; Purpose the device can lower the lamp in a higher position to the working surface, and then automatically lift the lamp to the original height and restore it to its original position after the electrical appliances are replaced or repaired. The device adopts remote control to control the lifting and lifting of lamps and lanterns. The device is applicable to such places as tall factory building, warehouse, sports factory hall, supermarket, logistics center, aircraft hangar, aircraft maintenance workshop and exhibition hall, etc.
Structure introduction:
1. The lighting power supply of the conductive part of the upper lamp lift is conducted when the conductive column and the conductive ring are tightly pressed (the pressure is 2kg/mm2dfs). The conductivity is 100%. When the two are in the state of separation, the lamp is in the state of no electricity, after the completion of the operation to rise to the original position, the two automatic compression.
2. Fixing and positioning of lamps and lanterns
When the lamp rises to the original position, the guide rod part of the device enters the guide hole part of the device accurately and automatically to achieve fixation and positioning, so as to prevent the swing of the lamp in a high position and make the lamp in a static state.
3 lifting weight series of high lamp lifter: lifting device load weight 8KG, 15KG, 30KG; Lift high
4. Collision prevention and safety guarantee of the upper lamp lifter.
When lifting the luminaire to the original position, the power supply of the control line will be cut off automatically and the lighting power will be turned on automatically by the travel switch.
5. Control part of the upper lamp lifter
The control part of the upper lamp lift is: wireless remote control one-to-one control
Installation form of upper lamp lift:
Ceiling type installation: lift should be installed vertically.
Connection form between the upper lamp lift and the lamp:
1. Threaded connection
2. Flange connection
3. Hook connection
The lamp type applicable to the upper lamp lift
It is suitable for all kinds of high pressure die-casting aluminum molding electrical boxes and lamps with high purity aluminum reflector.
Packaging requirements
1. The elevator manufactured by our company will be packaged in two layers.
Inner packing: plastic foam
Outer packing: corrugated carton: one box
2. The product instruction manual and lamps and lanterns are packed in the box.
3. The outer packing shall bear the logo of our company
Warning:
1. Power is strictly forbidden before the top of the elevator is installed!
2. The live wire of the line power supply is connected to the L terminal of the live wire and the zero terminal is connected to the N terminal of the lift. All live wires of the lift must be in the same phase; Lifting control system should be independent control!
3. Elevator must be installed vertically